Clutch concerns big savings Recently one of our jimsmustangsandcustoms.com customers brought his 2005 Ford Mustang GT in for a transmission noise. We test drove the vehicle noticing a noise at the higher revolution per minute (RPM). The clutch was not slipping but seemed difficult to shift into gears. There were no visible leaks from the master and slave clutch cylinders or transmission. We noticed that the trans fluid was very burned and broken down. The customer told us to go ahead and inspect both the transmission and clutch assembly. After the transmission was removed from the Mustang we noted the clutch disc was worn down all the way to the rivets. The pressure plate fingers were worn and had lost tinsel strength. The throw out bearing (part of the slave clutch cylinder) was noisy. The flywheel was hot spotted and needed to be resurfaced. The pilot bearing was rough on the inside and also needed to be replaced. We also replaced the rear main engine oil seal since it was leaking and we were already there.  Although the stock clutch set was well made and had lasted over 100,000 miles we suggested an improved application. Our customer agreed opting for our recommended parts manufacturer. We also drained out the old transmission fluid and refilled it with BG Synthetic fluid. There was no damage to the transmission because the customer brought in the Mustang when he first heard the noise. Had it been driven beyond the stopping point the input shaft may have become damaged by the pilot bearing and the internal bearings also may have failed spreading metal throughout the transmission. So clutch concerns big savings came about by avoiding transmission internal damage. The customer told us that “Justang” felt lighter,quieter and more powerful with the drivetrain updates and transmission services...